1. Related to EL356B

1.1 Bad quality of data transmission to winder drives (WIS), number of faulty messages.

1.2 Data transmission failure to the winder drives (WIS), number of program cycles without DTM

1.3 CAN actual value message (pressure roll) not received, id.

1.4 CAN actual value message (traverse system) not received, id.

1.5 CAN actual value message (chuck 2) not received, id.

1.6 Switch on not possible, because chuck not engaged

1.7 Speed measurement fault, Frequency 127.918132 Hz

1.8 Pressure roll DTM failure, CAN-channel
1.9 Traverse unit DTM failure, CAN-channel

2. Related to EL357B

2.1 Bad quality of data transmission to winder interface, number of faulty messages

2.2 Too low an operating pressure

2.3 Push-off device not retracted

2.4 String-up device not in home position, Winder interface input

3. Related to EA99/EA118

3.1 Undervoltage in DC-bus, Frequency 0.000000 Hz Voltage 210 V

3.2 Inverter not ready for operation

3.3 short current

3.4 Warning: short-circuit interruption, Frequency 0.000000 Hz Current 0.0 A

3.5 Start-up monitoring responded (winder drives), Time 5.0 s Step no. 1

3.6 Inverter out of operation (failure)

3.7 Safety time active (Sensor fault?), Time 60.0 s

3.8 Max. inverter frequency exceeded

4. Related to EL381C

4.1 Bad quality of data transmission to winder drives (WIS), number of faulty messages,

5. Related to EA95F

5.1 Emergency operation, winder, Winder interface input no. 36

6. Related to EPR

6.1 Error pressure control valve: operating parameters are faulty Step no.

7. Related to ED477A

7.1 Winder OS FE: drive channel CAN actual value message (chuck 1) not received, id.

7.2 Winder OS FE: drive channel CAN actual value message (chuck 2) not received, id.

7.3 Winder OS FE: drive channel CAN actual value message (traverse system) not received, id.

7.4 Winder OS FE: drive channel CAN actual value message (pressure roll) not received, id.

7.5 Chuck 1 OS FE: base channel DTM failure, CAN-channel

7.6 Chuck 2 OS FE: base channel DTM failure, CAN-channel

7.7 Traverse unit OS FE: base channel DTM failure, CAN-channel Pressure roll

7.8 OS FE: base channel DTM failure, CAN-channel